![]() Shielded cables are recommended if the analog signal is routed via cable extensions. The A255 robot system consists of an A255 arm and a C500C controller. This allows the arm to move a gripper or other tool to cartesian spatial coordinates and orientation defined by X, Y, Z, Z-rotation, Y-rotation, and Xrotation. Operability in case of contact with other media (coolant, acids, bases, etc.) is often given, however cannot be guaranteed by SCHUNK. The A255 arm is articulated with five joints or axes, providing it with five degrees of freedom. Set out materials 2.1.Carpet cushion/underlay and gripper accessories to be installed is checked against order 2.2.Carpet cushion/underlays are acclimatised according to manufacturer recommendations 2.3. IP67 when plugged in, for use in clean or dusty environments or in case of contact with water. point, to ensure efficiency and quality of installation 2. Disturbing magnetic fields can be generated by motors, electric welders, permanent magnets or magnetized material (so-called soft magnets) such as hexagon socket wrenches, chips, etc. Sensors can be influenced by other magnetic fields in the immediate vicinity. The 10 V sensor, on the other hand, can be directly connected to an analog input, for example a PLC or a separate input card. The 5 V sensor is optimized for operation with the SCHUNK FPS system. The MMS 22-A is available in versions with 5 or 10 V output voltage.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |